1 d

To disable the Load & Go™ syste?

Follow the hot and cold hoses from the water hookup to the machin?

You may notice during a cycle that the wash load is not completely submerged in water. This component is responsible for regulating the amount of water in the washer drum. Your clothes can be dirtier with high soil and stains trapped in them. Our experts share tips and tricks for a seamless design. danville va news 13 For a large load, the washer should be about three-quarters full. Over time, frequent use can deplete the fluid in the reservoir. Most water inlet valves require at least 20 psi to work correctly. (Ha)Again, thank you for all your help,Theresa See full list on jyfs. nathan clifford This prevents any potential accidents or water leakage. Is your washer refusing to spin? Don’t panic just yet. You can then: Turn off the washer and check the pump wire harness connections at the control board and pump. LG front load washers are known for their efficiency and advanced features. The low washer fluid light should now be reset. craigslist yard sales today Step 1: Refer to the wiring diagram of your GE washer and locate the terminals of the pressure switch. ….

Post Opinion